| View previous topic :: View next topic |
| Author |
Message |
splittyman69
Jedi Master
Joined: 09 Mar 2006
Posts: 282
|
 Posted: Wed Mar 21, 2007 8:03 am Post subject: asorted vw parts /other stuff take a look |
 |
|
hi all a few parts here if anyones instrested
original front doglegs for a 1963-68 splitscreen i bought these for my bus and are no longer required. they have been stripped and red oxided. there are a few areas of surface rust but id say they good conditon ,these will fit earlyer splitscreens but the only difference on a pre 63 is the arch lip below the door is deeper, but these will fit exactley the same. 150 (hens teeth)
fireglass front upright bug wings still in white primer 2inch wider then std 50.00 the pair
3 cream gauges with orange needles oil temp,volts clock all decent and g.w.o no senders 30.00
type 3 fastback window glass 5.00 each vw stamped
rear bug backplates complete shoes.clyinders,h,brake cables (thinner shoes type for wide 5 drums 40.00 the pair
type1 bug irs drums used 5.00 each
71 bug front seats been outside a while have some rubb and small rips on them but very useable 20.00
porshce 911 irs drive shafts 30.00 complete
90mph bug speedo vdo 10.00
rear 74 bug wings 25.00 new but surface rust
type3 hella interior light 5.00
tombstone rear bug lights complete 20.00
mk2 golf front engine struct brace
mk3 golf td 70amp alti 10.00
mk3 golf central locking pump 10.00
vw pair of clear slopering headlights fit splitsceen as well one has a stone chip in lense decent nick 40 .00 pair
found 2 pairs of tear drop rear lights one set is mint with brill crome and red glass lenses the other set are orange with plastic lenses 20 and 15
911 gearstick rubber,
911 seat belt holders and rubber
complete 911 fuse box and replys
911 heater control unit
911 igniton and switch no key
911 rear calipars (vented type all parts from a a reg 3.0sc 911 targa top) |
|
| Back to top |
|
 |
jp
Darth Admin
Joined: 09 Nov 2005
Posts: 1984
Location: Chippenham, Wiltshire
|
| Posted: Wed Mar 21, 2007 9:48 am Post subject: |
|
|
You got any pics of the 3 cream gauges ?
Would you be able to measure the 911 Driveshafts.. just wondering if they may fit my new rear 944 set up on my bus as have to use a 50mm spacer on the orig vw shafts 
Also any chance of measuring just the CV aswell
Much appreciated
_________________
1971 Devon Bay with 1800 Ford Turbo Diesel Engine (wip)
1983 VW Golf GTI Campaign
1979 Mini 1275 GT
2013 Scirocco TDI GT |
|
| Back to top |
|
|
splittyman69
Jedi Master
Joined: 09 Mar 2006
Posts: 282
|
| Posted: Wed Mar 21, 2007 8:30 pm Post subject: |
|
|
| jp wrote: | You got any pics of the 3 cream gauges ?
Would you be able to measure the 911 Driveshafts.. just wondering if they may fit my new rear 944 set up on my bus as have to use a 50mm spacer on the orig vw shafts
Also any chance of measuring just the CV aswell
Much appreciated |
hi pal here u go
one has a small dint on the bottom of the bezel look real classy thow
the porshce drives are complete and are the same size centre shaft as a type2 bay/i can measure them if needed
 |
|
| Back to top |
|
|
jp
Darth Admin
Joined: 09 Nov 2005
Posts: 1984
Location: Chippenham, Wiltshire
|
| Posted: Wed Mar 21, 2007 11:33 pm Post subject: |
|
|
Are the surrounds on the gauges chrome ? if yes is that £30 inc P&P  if so I'll have them 
Do you know if the overall length of the driveshafts (inc CV's) are the same as on the T2? basically I'm after an extra 50 mm as my porka hubs sit 50 mm further away from the G'box than the orig hubs.
pics here
_________________
1971 Devon Bay with 1800 Ford Turbo Diesel Engine (wip)
1983 VW Golf GTI Campaign
1979 Mini 1275 GT
2013 Scirocco TDI GT |
|
| Back to top |
|
|
splittyman69
Jedi Master
Joined: 09 Mar 2006
Posts: 282
|
| Posted: Thu Mar 22, 2007 8:24 am Post subject: |
|
|
| jp wrote: | Are the surrounds on the gauges chrome ? if yes is that £30 inc P&P if so I'll have them
Do you know if the overall length of the driveshafts (inc CV's) are the same as on the T2? basically I'm after an extra 50 mm as my porka hubs sit 50 mm further away from the G'box than the orig hubs.
pics here |
regarding gauges ill do them 30.00including postage yes there are crome and were in full working order,ill measure them 2day for u ,ill pm u my details  |
|
| Back to top |
|
|
jp
Darth Admin
Joined: 09 Nov 2005
Posts: 1984
Location: Chippenham, Wiltshire
|
| Posted: Thu Mar 22, 2007 9:15 am Post subject: |
|
|
Cool I'll hang on until you measue driveshaft before sending cheque up just in case they fit the bill 
_________________
1971 Devon Bay with 1800 Ford Turbo Diesel Engine (wip)
1983 VW Golf GTI Campaign
1979 Mini 1275 GT
2013 Scirocco TDI GT |
|
| Back to top |
|
|
splittyman69
Jedi Master
Joined: 09 Mar 2006
Posts: 282
|
| Posted: Thu Mar 22, 2007 10:02 am Post subject: |
|
|
| jp wrote: | | Cool I'll hang on until you measue driveshaft before sending cheque up just in case they fit the bill |
right measured the drive shafts there 19 and 3/4 inches long including the cvs , it helps jp. |
|
| Back to top |
|
|
jp
Darth Admin
Joined: 09 Nov 2005
Posts: 1984
Location: Chippenham, Wiltshire
|
| Posted: Fri Mar 23, 2007 12:09 am Post subject: |
|
|
Cheers for the measurement.. I have just measured my bay ones and they are 18inches which means yours are 1 and 3/4 inches longer.. which means they should be perfect !! too good to be true surely.. here's how I measured my 18inches
sorry for the phone camera crap pics.. if i push the CV's in as much as they go I'm look at 17inches and 19inches if I pull them out (outside of cv to cv) if yours are 19 and 3/4 with movement either way then excellent.
Do you know if the CV's are the same as on the bay I'm assuming they are ?
How much do you want for shafts and Gauges inc post to Bristol ?
cheers
_________________
1971 Devon Bay with 1800 Ford Turbo Diesel Engine (wip)
1983 VW Golf GTI Campaign
1979 Mini 1275 GT
2013 Scirocco TDI GT |
|
| Back to top |
|
|
splittyman69
Jedi Master
Joined: 09 Mar 2006
Posts: 282
|
| Posted: Fri Mar 23, 2007 8:26 am Post subject: |
|
|
| im 98percent these will do the job for you jp ill double check and check agaist a type2 cv as ive some them as well lol as with the cv shoved fully in i get no were nere as short as yours gauges/drive 60.00 and 15.00 delivery if postage works out any cheeper ill refuned it in the parcel jp/ |
|
| Back to top |
|
|
richbaker78
Teacher of Padawans
Joined: 31 Jan 2006
Posts: 1298
|
| Posted: Fri Mar 23, 2007 8:56 am Post subject: |
|
|
splittyman can you tell us what model and year car these shafts came off of?
sounds like im gona need some too if JPs fit the bill |
|
| Back to top |
|
|
jp
Darth Admin
Joined: 09 Nov 2005
Posts: 1984
Location: Chippenham, Wiltshire
|
| Posted: Fri Mar 23, 2007 9:23 am Post subject: Re: asorted vw parts /other stuff take a look |
|
|
| splittyman69 wrote: | | (all parts from a a reg 3.0sc 911 targa top) |
!
_________________
1971 Devon Bay with 1800 Ford Turbo Diesel Engine (wip)
1983 VW Golf GTI Campaign
1979 Mini 1275 GT
2013 Scirocco TDI GT |
|
| Back to top |
|
|
jp
Darth Admin
Joined: 09 Nov 2005
Posts: 1984
Location: Chippenham, Wiltshire
|
| Posted: Fri Mar 23, 2007 9:26 am Post subject: |
|
|
| splittyman69 wrote: | | im 98percent these will do the job for you jp ill double check and check agaist a type2 cv as ive some them as well lol as with the cv shoved fully in i get no were nere as short as yours gauges/drive 60.00 and 15.00 delivery if postage works out any cheeper ill refuned it in the parcel jp/ |
Excellent stuff let us know when you've checked the CV and I'll get a cheque in the post
_________________
1971 Devon Bay with 1800 Ford Turbo Diesel Engine (wip)
1983 VW Golf GTI Campaign
1979 Mini 1275 GT
2013 Scirocco TDI GT |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
