Posted: Fri Dec 19, 2008 6:02 pm Post subject: Heater bypass location
Where is best to fit the RJES heater bypass valve on a t25?
1.Just before the shut off valve up front?
2. Or right at the engine end?
Its just a thought' but if i fit it up front i should gain a little drop in coolant temp via temp loss in the heater hose's Or would this be so minimal id waste my time cutting and joinig pipes for no advantage?
Joined: 30 Jan 2006 Posts: 652 Location: North Staffordshire
Posted: Sat Dec 20, 2008 1:19 pm Post subject:
Functionally, it won't make any difference. I fit them at the back a few inches forward of the 'firewall' (between the starte rsolenoid and the fuel tank on a Syncro), as they provide a convenient bridging piece between my moulded hoses and the VW hose. That way, there is no need to disturb any of the heater plumbing forward of the engine bay. Hope that helps. _________________ Regards,
Richard,
R J Engineered Solutions
Quality Subaru Powered VW Components
www.rjes.com
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
