Joined: 17 May 2006 Posts: 297 Location: Dorset/Bristol
Posted: Sun Mar 08, 2009 10:48 am Post subject: AAZ senders and pump wiring
Hi,
Would some one be able to tell me what these two senders do, there's the one pictured and another further down behind the blue clip. Am I right in thinking the one shown is the coolant temp sender- what does the other one do? there's 4 wires running to it. I didn't think it was the fan switch as that was on the rad?
What are these wires to the pump do? In the haynes theres only reference to the fuel cut off - which I'm assuming is the one at the bottom. There's another 3 - with two of them having 2 wires running to them. How should I wire up these on the pump? is it simply to point 2 on the ignition with an earth where there's two wires?
2 wires running to this one, it's at the bottom on the side of the pump.
Joined: 17 May 2006 Posts: 297 Location: Dorset/Bristol
Posted: Thu Mar 12, 2009 6:38 pm Post subject: Re: AAZ senders and pump wiring
Hi,
Encase any one else needs to know, i tested the two senders on a dummy circuit with a heat gun, the one pictured below on the rubber hose is a fan switch, the sender nearer the head is the sender for the temp gauge.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
