need someone to install my drive train in my split screen

pantswagen · Padawan Joined: 05 Oct 2006 Posts: 73

basically have a t25 a/c 091
rjes bell
twin cam scoob
stailess header
----------------------------
want
1. side shifter extension
2. t25 style front mounting-gearbox close to torsion housing
3. over the top hoop, t25 style mounting - to chassis - laser cut flats-tied together
4.engine hanger
5. it raised up some
6. the old hoopage cut out
7.stainless exhaust fabricated, from the header
8. will pay for quality

-its a truck - so the tank isn't on the bulk-head
-that all gets trimmmed a bit - or cut out so the top hanger can go in

some one in the country must be able toquote for it?

rjes · Posted: Fri Jan 30, 2009 12:43 am Post subject:

Because of the custom fabrication work involved, I would have thought your best bet would be to try the race car fabricators, rather than general VW garages. I'm sure any of the following would do a good job:

Jon Rathbone Racing (Stoke on Trent)
Wayne Allman - Intergalactic Customs (Stratford - ish?)
Daryn Coleman - DC Customs (Birmingham)
Rob Judge - RNJ Motorsport
_________________
Regards,

Richard,

R J Engineered Solutions
Quality Subaru Powered VW Components
www.rjes.com

doppelganger · Posted: Fri Jan 30, 2009 1:05 pm Post subject:

if you want i can ask all of them barring john rathbone

where are you based?
_________________
vwdrc class rep

vwdrc AE bugjam winner
11.23@127mph. 1.47 60ft. 2.85sec 0-60mph

pantswagen · Padawan Joined: 05 Oct 2006 Posts: 73

west london