breakin it down..

[joodge]

Hi guys,
thought id put it to the forum.. rich B.. not sure if this is a sale or wanted or general query!!!
i am trying to sell my lawn mower engine with below spec..
shuffle pinned aftermarket aluminium case type 1
2187cc
94mm bore on the cylinders
78.8mm on the crankshaft
engle 130 camshaft
37x32 mm portred vw cylinders heads
cromoly pushrods
swivel feet tappets
bolt up rocker shafts
2 x twin choke 36 drla carbs
full flow oil system with 4 litre sump for extra cooling
only VW parts are heads (gas flowed), con rods, rockers, cam plug (!) plus all the tinware, cooling system and charging system
1.1/2" merged collector with single quiet pack muffler

and have thought that it as its supped up in each department it might be easier to break down and sell individually.. only problem is i am not sure what of the above i could sell on and and is it likely i would be left with loadsa bits and pieces and it wouldnt be worth doing it this way at all.. so the key is what bits of the above can i sell individually and are there any expensive bits that i would have trouble selling independantly.. your opinions once again would be valued chaps

peace out and have a good weekend